Humboldt Filling Machines 300 Series Cone Filling Machine Starter Kit

• Loads up to 389 cones per session 
• Available in 70mm, 84mm, 98mm classic, and 109mm cone size 
• Easy clean-up 

• Filling Machine Cartridge
• Detachable Base
  
• Tamping Tool
• Vibration Table
• Stabilization Mat
• Extension Cord with Power Switch

1. Set the vibration table on the stabilization mat.

2. Plug the vibration table into the switched extension cord.
3. Plug the extension cord into a power outlet.
4. Place the cartridge on the vibration table; ensure the detachable base is firmly installed.
5. Fill the holes of the cartridge with your cones.
6. Turn on the vibration table using the switch on the extension cord.
7. Fill the top of the cartridge with your material and the vibration action will shake your material into the cones.
8. Use the included tamping tool to pack your material during operation.  PLEASE NOTE: Firmly tamp your material early in the filling process to ensure a firm, crisp, tight pack right near the crutch.
9. Once your cones are nearly full (leave some space at the end to twist), turn the vibration table off.
10. Pick up the cartridge and remove the detachable base by releasing the red clamps.
11. Set the cartridge top down on a flat surface, and the cones will be pushed up so that they are accessible.
12. Remove each cone and twist the end to finish.

Our filling machines can be cleaned with hot water up to 130º F but will warp over time if used in a dishwasher.   We recommend using an isopropyl (rubbing alcohol) and salt mixture, commonly used to remove plant resin and residue.  Please do not expose our machines to temperatures over 130º or leave outdoors in direct sunlight.